• Home
  • 4649-12CN240 Tanged Non-Locking Insert, M12X1.25; Stainless Steel; 2 Dia.; Bulk

4649-12CN240 Tanged Non-Locking Insert, M12X1.25; Stainless Steel; 2 Dia.; Bulk

SKU: 60596 | MPN: 4649-12CN240
/ Eaches
Subtotal:$0.00
Quantity Available *
QuantityLocation
8Bolingbrook
WARNING: Cancer and Reproductive Harm --
P65Warnings.ca.gov
Discount by: unit
QuantityPrice
*Additional inventory may be available. Please contact your sales location.

Details

Specifications
Thread SizeM12X1.25
CoatingNo Finish
Wire Insert SeriesNon-Locking
Wire Insert TypeTanged
MaterialStainless Steel
Material304 Stainless Steel
Length Nominal Dia.2 Dia.
Material SpecificationAS7245
Number of Free Coils15-7/8
Free Coil Diameter Min.14.30 mm
Free Coil Diameter Max.15.00 mm
Finish Specificationn/a
 
Drilling Data
Minimum Drilling Depth for Bottoming Taps29.00 mm
Minimum Drilling Depth for Plug Taps31.50 mm
Drilling InformationThe minimum drilling depths shown below allow for the following recommended practices: 1. Countersinking the drilled hole to prevent a feather edge at the start of the tapped hole. 2. 3/4 - 1-1/2 pitch of insert "set-down" to allow for maximum production tolerance. Dimensions are shown for both plug and bottoming taps. (Note: Plug taps M8 and smaller have a male center and the drilled hole depth dimensions allow for this length (one half of the diameter of the holt). Calculation of dimension "F" is as follows: For Plug Taps M8 and smaller: F = Insert Nominal Length (Q) + .5 (Bolt Nominal Diameter) + 4P (Tap Chamfer) + 1P (allowance for countersink and maximum insert set-down). For Plug Taps M10 and larger: F = Insert Nominal Length(Q) + 4P (Tap Chamfer) + 1P (allowance for countersink and maximum insert set-down). For Bottoming Taps: F = Insert Nominal Length (Q) + 2P (Tap Chamfer) + 1P (allowance for countersink and maximum insert set-down).
 
Tapping Data
Countersink Diameter Min.14.10 mm
Countersink Diameter Max.13.50 mm
Pitch Diameter Min.12.81 mm
Pitch Diameter Max. ~ Class of Fit 4H_mm12.90 mm
Pitch Diameter Max. ~ Class of Fit 5H_mm12.93 mm
Minimum Tapping Depth25.30 mm
Tap Major Diameter Max.13.79 mm
 
Reference
Aerospace Standard Part NumberMA3279-212