• Home
  • 4266-18TN180 Tanged Non-Locking Insert, M18X2; Inconel; 1 Dia.; Bulk

4266-18TN180 Tanged Non-Locking Insert, M18X2; Inconel; 1 Dia.; Bulk

SKU: 69616 | MPN: 4266-18TN180
/ Eaches
Subtotal:$0.00
WARNING: Cancer and Reproductive Harm --
P65Warnings.ca.gov
Discount by: unit
QuantityPrice
*Additional inventory may be available. Please contact your sales location.

Details

Specifications
Thread SizeM18X2
CoatingNo Finish
Wire Insert SeriesNon-Locking
Wire Insert TypeTanged
MaterialInconel X
MaterialInconel X-750
Length Nominal Dia.1 Dia.
Material SpecificationAS7246
Number of Free Coils7
Free Coil Diameter Min.21.15 mm
Free Coil Diameter Max.21.85 mm
Finish Specificationn/a
 
Drilling Data
Minimum Drilling Depth for Bottoming Taps26.00 mm
Minimum Drilling Depth for Plug Taps30.00 mm
Drilling InformationThe minimum drilling depths shown below allow for the following recommended practices: 1. Countersinking the drilled hole to prevent a feather edge at the start of the tapped hole. 2. 3/4 - 1-1/2 pitch of insert "set-down" to allow for maximum production tolerance. Dimensions are shown for both plug and bottoming taps. (Note: Plug taps M8 and smaller have a male center and the drilled hole depth dimensions allow for this length (one half of the diameter of the holt). Calculation of dimension "F" is as follows: For Plug Taps M8 and smaller: F = Insert Nominal Length (Q) + .5 (Bolt Nominal Diameter) + 4P (Tap Chamfer) + 1P (allowance for countersink and maximum insert set-down). For Plug Taps M10 and larger: F = Insert Nominal Length(Q) + 4P (Tap Chamfer) + 1P (allowance for countersink and maximum insert set-down). For Bottoming Taps: F = Insert Nominal Length (Q) + 2P (Tap Chamfer) + 1P (allowance for countersink and maximum insert set-down).
 
Tapping Data
Countersink Diameter Min.21.10 mm
Countersink Diameter Max.20.50 mm
Pitch Diameter Min.19.30 mm
Pitch Diameter Max. ~ Class of Fit 4H_mm19.41 mm
Pitch Diameter Max. ~ Class of Fit 5H_mm19.44 mm
Minimum Tapping Depth20.00 mm
Tap Major Diameter Max.20.82 mm