• Home
  • 3591-14CNW1312 Tanged Locking Insert

3591-14CNW1312 Tanged Locking Insert

SKU: 97733 | MPN: 3591-14CNW1312
/ Eaches
Subtotal:$0.00
WARNING: Cancer and Reproductive Harm --
P65Warnings.ca.gov
Discount by: unit
QuantityPrice
*Additional inventory may be available. Please contact your sales location.

Details

Specifications
Thread Size7/8-14
CoatingDry Film Lubricant
Wire Insert SeriesLocking
Wire Insert TypeTanged
MaterialStainless Steel
Material304 Stainless Steel
Length Nominal Dia.1-1/2 Dia.
Material SpecificationAS7245
Number of Free Coils15-1/2
Free Coil Diameter Min.1.021 in
Free Coil Diameter Max.1.051 in
Finish SpecificationAS5272 (Type I)
Finish AppearanceDark Gray to Black
 
Locking Torque Data
Locking Torque Max.600 in·lb
Locking Torque Min. 15th Cycle70.0 in·lb
 
Drilling Data
Suggested Drill Size ~ Aluminum57/64
Suggested Drill Size ~ Steel, Magnesium, Plastic57/64
Minimum Drilling Depth for Bottoming Taps1.598 in
Minimum Drilling Depth for Plug Taps1.741 in
Drilling InformationThe minimum drilling depths shown below allow for the following recommended practices: 1. Countersinking the drilled hole to prevent a feather edge at the start of the tapped hole. 2. 3/4 - 1-1/2 pitch of insert ""set-down"" to allow for maximum production tolerance. Dimensions are shown for both plug and bottoming taps. (Note: Plug taps 5/16"" and smaller have a male center and the drilled hole depth dimensions allow for this length (one half of the diameter of the holt). Calculation of dimension ""F"" is as follows For Plug Taps 5/16"" and smaller: F = Insert Nominal Length (Q) + .5 (Bolt Nominal Diameter) + 4P (Tap Chamfer) + 1P (allowance for countersink and maximum insert set-down). For Plug Taps 3/8"" and larger: F = Insert Nominal Length(Q) + 4P (Tap Chamfer) + 1P (allowance for countersink and maximum insert set-down). For Bottoming Taps: F = Insert Nominal Length (Q) + 2P (Tap Chamfer) + 1P (allowance for countersink and maximum insert set-down).
 
Tapping Data
Countersink Diameter Min..960 in
Countersink Diameter Max..990 in
Pitch Diameter Min..921 in
Pitch Diameter Max. ~ Class of Fit 3B_in.926 in
Pitch Diameter Max. ~ Class of Fit 2B_in.927 in
Minimum Tapping Depth1.380 in
Tap Major Diameter Max..972 in
 
Taps & Gages
Tap Roughing14CRU
Tap Straight Flute Bottoming 2B20193-14
Tap Straight Flute Bottoming 3B10193-14
Tap Straight Flute Plug 2B18193-14
Tap Straight Flute Plug 3B8193-14
Reference Gage 2B1441-14
Reference Gage 3B1694-14