• Home
  • 3585-9TN1125 Tanged Locking Insert

3585-9TN1125 Tanged Locking Insert

SKU: 97382 | MPN: 3585-9TN1125
/ Eaches
Subtotal:$0.00
WARNING: Cancer and Reproductive Harm --
P65Warnings.ca.gov
Discount by: unit
QuantityPrice
*Additional inventory may be available. Please contact your sales location.

Details

Specifications
Thread Size9/16-12
CoatingNo Finish
Wire Insert SeriesLocking
Wire Insert TypeTanged
MaterialInconel X
MaterialInconel X-750
Length Nominal Dia.2 Dia.
Material SpecificationAS7246
Number of Free Coils11-1/2
Free Coil Diameter Min..669 in
Free Coil Diameter Max..694 in
Finish Specificationn/a
 
Locking Torque Data
Locking Torque Max.200 in·lb
Locking Torque Min. 15th Cycle30.0 in·lb
 
Drilling Data
Suggested Drill Size ~ Aluminum37/64
Suggested Drill Size ~ Steel, Magnesium, Plastic19/32
Minimum Drilling Depth for Bottoming Taps1.457 in
Minimum Drilling Depth for Plug Taps1.624 in
Drilling InformationThe minimum drilling depths shown below allow for the following recommended practices: 1. Countersinking the drilled hole to prevent a feather edge at the start of the tapped hole. 2. 3/4 - 1-1/2 pitch of insert ""set-down"" to allow for maximum production tolerance. Dimensions are shown for both plug and bottoming taps. (Note: Plug taps 5/16"" and smaller have a male center and the drilled hole depth dimensions allow for this length (one half of the diameter of the holt). Calculation of dimension ""F"" is as follows For Plug Taps 5/16"" and smaller: F = Insert Nominal Length (Q) + .5 (Bolt Nominal Diameter) + 4P (Tap Chamfer) + 1P (allowance for countersink and maximum insert set-down). For Plug Taps 3/8"" and larger: F = Insert Nominal Length(Q) + 4P (Tap Chamfer) + 1P (allowance for countersink and maximum insert set-down). For Bottoming Taps: F = Insert Nominal Length (Q) + 2P (Tap Chamfer) + 1P (allowance for countersink and maximum insert set-down).
 
Tapping Data
Countersink Diameter Min..660 in
Countersink Diameter Max..690 in
Pitch Diameter Min..617 in
Pitch Diameter Max. ~ Class of Fit 3B_in.621 in
Pitch Diameter Max. ~ Class of Fit 2B_in.622 in
Minimum Tapping Depth1.210 in
Tap Major Diameter Max..675 in
 
Taps & Gages
Tap Roughing9CRU
Tap Straight Flute Bottoming 2B43187-9
Tap Straight Flute Bottoming 3B4187-9
Tap Straight Flute Plug 2B38187-9
Tap Straight Flute Plug 3B187-9
Reference Gage 2B1440-9
Reference Gage 3B1688-9