• Home
  • 1191-161GN2500 Tanged Non-Locking Insert, 1-12; Titanium; 2-1/2 Dia.

1191-161GN2500 Tanged Non-Locking Insert, 1-12; Titanium; 2-1/2 Dia.

SKU: 102692 | MPN: 1191-161GN2500
/ Eaches
Subtotal:$0.00
WARNING: Cancer and Reproductive Harm --
P65Warnings.ca.gov
Discount by: unit
QuantityPrice
*Additional inventory may be available. Please contact your sales location.

Details

Specifications
Thread Size1-12
CoatingNo Finish
Wire Insert SeriesNon-Locking
Wire Insert TypeTanged
MaterialTitanium
MaterialTitanium
Length Nominal Dia.2-1/2 Dia.
Material SpecificationAMS 4957 & AMS 4958A
Number of Free Coils26
Free Coil Diameter Min.1.169 in
Free Coil Diameter Max.1.199 in
Finish Specificationn/a
 
Drilling Data
Suggested Drill Size ~ Aluminum1 1/64
Suggested Drill Size ~ Steel, Magnesium, Plastic1 1/32
Minimum Drilling Depth for Bottoming Taps2.833 in
Minimum Drilling Depth for Plug Taps3.000 in
Drilling InformationThe minimum drilling depths shown below allow for the following recommended practices: 1. Countersinking the drilled hole to prevent a feather edge at the start of the tapped hole. 2. 3/4 - 1-1/2 pitch of insert ""set-down"" to allow for maximum production tolerance. Dimensions are shown for both plug and bottoming taps. (Note: Plug taps 5/16"" and smaller have a male center and the drilled hole depth dimensions allow for this length (one half of the diameter of the holt). Calculation of dimension ""F"" is as follows For Plug Taps 5/16"" and smaller: F = Insert Nominal Length (Q) + .5 (Bolt Nominal Diameter) + 4P (Tap Chamfer) + 1P (allowance for countersink and maximum insert set-down). For Plug Taps 3/8"" and larger: F = Insert Nominal Length(Q) + 4P (Tap Chamfer) + 1P (allowance for countersink and maximum insert set-down). For Bottoming Taps: F = Insert Nominal Length (Q) + 2P (Tap Chamfer) + 1P (allowance for countersink and maximum insert set-down).
 
Tapping Data
Countersink Diameter Min.1.100 in
Countersink Diameter Max.1.130 in
Pitch Diameter Min.1.054 in
Pitch Diameter Max. ~ Class of Fit 3B_in1.059 in
Pitch Diameter Max. ~ Class of Fit 2B_in1.061 in
Minimum Tapping Depth2.580 in
Tap Major Diameter Max.1.113 in
 
Taps & Gages
Tap Roughing161CRU
Tap Straight Flute Bottoming 2B20193-161
Tap Straight Flute Bottoming 3B10193-161
Tap Straight Flute Plug 2B18193-161
Tap Straight Flute Plug 3B8193-161
Reference Gage 2B1441-161
Reference Gage 3B1694-161