• Home
  • 1185-6GN750 Tanged Non-Locking Insert, 3/8-16; Titanium; 2 Dia.

1185-6GN750 Tanged Non-Locking Insert, 3/8-16; Titanium; 2 Dia.

SKU: 39074 | MPN: 1185-6GN750
/ Eaches
Subtotal:$0.00
Quantity Available *
QuantityLocation
2,567Bolingbrook
WARNING: Cancer and Reproductive Harm --
P65Warnings.ca.gov
Discount by: unit
QuantityPrice
*Additional inventory may be available. Please contact your sales location.

Details

Specifications
Thread Size3/8-16
CoatingNo Finish
Wire Insert SeriesNon-Locking
Wire Insert TypeTanged
MaterialTitanium
MaterialTitanium
Length Nominal Dia.2 Dia.
Material SpecificationAMS 4957 & AMS 4958A
Number of Free Coils10
Free Coil Diameter Min..452 in
Free Coil Diameter Max..472 in
Finish Specificationn/a
 
Drilling Data
Suggested Drill Size ~ AluminumX
Suggested Drill Size ~ Steel, Magnesium, PlasticX
Minimum Drilling Depth for Bottoming Taps1.000 in
Minimum Drilling Depth for Plug Taps1.125 in
Drilling InformationThe minimum drilling depths shown below allow for the following recommended practices: 1. Countersinking the drilled hole to prevent a feather edge at the start of the tapped hole. 2. 3/4 - 1-1/2 pitch of insert ""set-down"" to allow for maximum production tolerance. Dimensions are shown for both plug and bottoming taps. (Note: Plug taps 5/16"" and smaller have a male center and the drilled hole depth dimensions allow for this length (one half of the diameter of the holt). Calculation of dimension ""F"" is as follows For Plug Taps 5/16"" and smaller: F = Insert Nominal Length (Q) + .5 (Bolt Nominal Diameter) + 4P (Tap Chamfer) + 1P (allowance for countersink and maximum insert set-down). For Plug Taps 3/8"" and larger: F = Insert Nominal Length(Q) + 4P (Tap Chamfer) + 1P (allowance for countersink and maximum insert set-down). For Bottoming Taps: F = Insert Nominal Length (Q) + 2P (Tap Chamfer) + 1P (allowance for countersink and maximum insert set-down).
 
Tapping Data
Countersink Diameter Min..450 in
Countersink Diameter Max..480 in
Pitch Diameter Min..416 in
Pitch Diameter Max. ~ Class of Fit 3B_in.419 in
Pitch Diameter Max. ~ Class of Fit 2B_in.420 in
Minimum Tapping Depth.810 in
Tap Major Diameter Max..460 in
 
Taps & Gages
Tap High Spiral Flute Bottoming 2B6905-6
Tap High Spiral Flute Bottoming 3B5905-6
Tap Roughingn/a
Tap Spiral Point Plug 2B6CSA
Tap Spiral Point Plug 3B6CSB
Tap Straight Flute Bottoming 2B6CBA
Tap Straight Flute Bottoming 3B6CBB
Tap Straight Flute Plug 2B6CPA
Tap Straight Flute Plug 3B6CPB
Reference Gage 2B1440-6
Reference Gage 3B1688-6
Working Gage 2B3688-6
Working Gage 3B1442-6