| Specifications |
|---|
| Thread Size | M18X2.5 |
| Coating | Silver |
| Wire Insert Series | Non-Locking |
| Wire Insert Type | Tanged |
| Material | Inconel X |
| Material | Inconel X-750 |
| Length Nominal Dia. | 2-1/2 Dia. |
| Material Specification | AS7246 |
| Number of Free Coils | 15-5/8 |
| Free Coil Diameter Min. | 21.30 mm |
| Free Coil Diameter Max. | 22.00 mm |
| Finish Specification | QQ-S-365 |
| Finish Appearance | Silver White |
| |
| Drilling Data |
|---|
| Minimum Drilling Depth for Bottoming Taps | 55.00 mm |
| Minimum Drilling Depth for Plug Taps | 60.00 mm |
| Drilling Information | The minimum drilling depths shown below allow for the following recommended practices: 1. Countersinking the drilled hole to prevent a feather edge at the start of the tapped hole. 2. 3/4 - 1-1/2 pitch of insert "set-down" to allow for maximum production tolerance. Dimensions are shown for both plug and bottoming taps. (Note: Plug taps M8 and smaller have a male center and the drilled hole depth dimensions allow for this length (one half of the diameter of the holt). Calculation of dimension "F" is as follows: For Plug Taps M8 and smaller: F = Insert Nominal Length (Q) + .5 (Bolt Nominal Diameter) + 4P (Tap Chamfer) + 1P (allowance for countersink and maximum insert set-down). For Plug Taps M10 and larger: F = Insert Nominal Length(Q) + 4P (Tap Chamfer) + 1P (allowance for countersink and maximum insert set-down). For Bottoming Taps: F = Insert Nominal Length (Q) + 2P (Tap Chamfer) + 1P (allowance for countersink and maximum insert set-down). |
| |
| Tapping Data |
|---|
| Countersink Diameter Min. | 21.20 mm |
| Countersink Diameter Max. | 21.80 mm |
| Pitch Diameter Min. | 19.62 mm |
| Pitch Diameter Max. ~ Class of Fit 4H_mm | 19.74 mm |
| Pitch Diameter Max. ~ Class of Fit 5H_mm | 19.78 mm |
| Minimum Tapping Depth | 47.50 mm |
| Tap Major Diameter Max. | 21.51 mm |
| |
| Taps & Gages |
|---|
| Tap Roughing | 3765-18 |
| Tap Straight Flute Bottoming 4H5H | 4693-18 |
| Tap Straight Flute Bottoming 5H | 2093-18 |
| Tap Straight Flute Plug 4H5H | 4687-18 |
| Tap Straight Flute Plug 5H | 2087-18 |
| Reference Gage 4H | 4624-18 |
| Reference Gage 5H | 1324-18 |