• Home
  • 3585-04BN224 Tanged Locking Insert
Prop 65 warning

3585-04BN224 Tanged Locking Insert

SKU: 66096 | MPN: 3585-04BN224
/ Eaches
Discount by: unit
1 - 49
50 - 99
100 - 499
500 - 999
1000 - 4999
5000 - 9999
10000 - 24999
25000 - 49999
50000 - 99999
100000 +


Thread Size#4-40
CoatingNo Finish
Wire Insert SeriesLocking
Wire Insert TypeTanged
MaterialPhosphor Bronze
MaterialPhosphor Bronze
Length Nominal Dia.2 Dia.
Material SpecificationASTM B159-01 per UNS C51000 Grade A
Number of Free Coils6-3/4
Free Coil Diameter Min..144 in
Free Coil Diameter Max..159 in
Finish Specificationn/a
Locking Torque Data
Locking Torque Max.48 in·oz
Locking Torque Min. 15th Cycle10 in·oz
Drilling Data
Suggested Drill Size ~ Aluminum#31
Suggested Drill Size ~ Steel, Magnesium, Plastic#31
Minimum Drilling Depth for Bottoming Taps.324 in
Minimum Drilling Depth for Plug Taps.430 in
Drilling InformationThe minimum drilling depths shown below allow for the following recommended practices: 1. Countersinking the drilled hole to prevent a feather edge at the start of the tapped hole. 2. 3/4 - 1-1/2 pitch of insert ""set-down"" to allow for maximum production tolerance. Dimensions are shown for both plug and bottoming taps. (Note: Plug taps 5/16"" and smaller have a male center and the drilled hole depth dimensions allow for this length (one half of the diameter of the holt). Calculation of dimension ""F"" is as follows For Plug Taps 5/16"" and smaller: F = Insert Nominal Length (Q) + .5 (Bolt Nominal Diameter) + 4P (Tap Chamfer) + 1P (allowance for countersink and maximum insert set-down). For Plug Taps 3/8"" and larger: F = Insert Nominal Length(Q) + 4P (Tap Chamfer) + 1P (allowance for countersink and maximum insert set-down). For Bottoming Taps: F = Insert Nominal Length (Q) + 2P (Tap Chamfer) + 1P (allowance for countersink and maximum insert set-down).
Tapping Data
Countersink Diameter Min..140 in
Countersink Diameter Max..170 in
Pitch Diameter Min..128 in
Pitch Diameter Max. ~ Class of Fit 3B_in.130 in
Pitch Diameter Max. ~ Class of Fit 2B_in.131 in
Minimum Tapping Depth.250 in
Tap Major Diameter Max..147 in
Taps & Gages
Tap High Spiral Flute Bottoming 2B6905-04
Tap High Spiral Flute Bottoming 3B5905-04
Tap Spiral Point Plug 2B04CSA
Tap Spiral Point Plug 3B04CSB
Tap Straight Flute Bottoming 2B04CBA
Tap Straight Flute Bottoming 3B04CBB
Tap Straight Flute Plug 2B04CPA
Tap Straight Flute Plug 3B04CPB
Reference Gage 2B1440-04
Reference Gage 3B1688-04
Working Gage 2B3688-04
Working Gage 3B1442-04